pobd2.com Intelligent Programming Charge Power Supply UD-12V 2700

Features:
1. Can Automatically detect and fix according to the health status of the battery.
2. Can charge the battery inside and outside the car, as well as battery repairing.
3. Can repair kinds of batteries, such as ordinary lead-acid batteries, AGM, GEL, VRLA, and others when charging.
4. Automatic Detection Mode, Charging Mode, Exhibit mode, Programming Mode, Battery Repairing Mode.
5. Constant current charging can be any character set.
Steps to use this Intelligent Power supply Charger:
1、Connect the battery and charger.
2、Choose the right mode according the actual situation of the battery and the table below, noted, if the mode outside vehicle is chosen, make sure the
battery is out of  the car. After finishing this step, press start and the consequential charging will be active.
3、If you connect the battery correctly and it shows poor contact, just press the right button and handle according the tips,
enable the Mode Enforce Charging.
4、In the programming mode, the voltage cannot be adjusted in Mode 2, and it can be adjusted in Mode 1.
      Press the Right and Down Button at the same time and you can adjust the voltage using the Up and Down Button after hearing “Beep”
      Then press Right and Down Button again to exit the adjust mode. Press start to begin charging.
1、Right / Left
2、Up / Down
3、Switch
4、Monitor
5、Over Charge Protection
6、Over Heat Protection
7、Low Voltage Protection
8、Short Circuit Protection
9、Revert Polarity Protection*Long-press the left key and the right key at the same time to switch between Chinese and English

Intelligent Programming Charge Power Supply UD-12V2700